Product Description

Set of 4 chrome wheel well moldings. They are about 1.5 inches wide and you can install them using either mounting clips, mounting screws or both. They will not fit if your truck has any kind of fender flares.

---

Product Details

• Amazon Sales Rank: #70001 in Automotive
• Brand: Restyling Ideas

Features

• No drilling required for installation.
• Made of highly polished stainless steel so they won't rust or corrode.
• Includes a rubber moulding to ensure a tight fit and protect fenders from scratches.
• Very easy and quick installation.
• Give your truck that OEM chrome look!

---

Customer Reviews

Most helpful customer reviews

4 of 4 people found the following review helpful.
they look great on my truck except...
By James C. McPeak
They are about 3/4 inch short on the front fender wells. On my 2010 Ford F-150, but other than that they look great. You really need two people to install correctly so you don't scratch the side of your truck. would recommend..

0 of 0 people found the following review helpful.
Very Pleased .. with a small "glitch"
By REC III
Received the product.. EARLY... A "Happy Camper"

BUT.. no installation instruction included... Sent an emal to "Auto Solutions".. Received a reply within THREE HOURS
HOW ABOUT THAT ... MY FREINDS.

They sent me a email (attachment) copy of the installation instructions.... AND I was off to install the fender trims..

The rear fender wells on my 2010 F-150 XLT "Super Cab" was a snap wiith the tabs.... it was done in TEN MNUTES .
I decidsed to use additonal screws on the lower front and rear attachmnet points as it would get the most wind... especially at high speeds..

The front trim was a different matter.... I had to remove the screws supporting the interior fender skirt to have enough room to bend the tabs.. The instructions do say remove flaps.... but not shirts... so be aware of this issue.

The fender trims looks SUPER... almost custom.... for very little "coin"

Buiy them.. for sure.... . if you want that look..
Was going to put "stainlesss steel" rocker panels on .. BUT no need .. these fender trim ....
are all you need.... unless you are a "chrome fanatic ".. Not a bad thing on motorcycles and racing boats
with "bright" sunshine.. just imagine.....

Again, Customer Service for "Auto Solutions" was " ABOVE THE MARK" will buy from them.. again... for sure